- GenericPrinter grows upload_project_file, send_gcode_line, and a
generic upload_gcode<P> driver that streams a whole gcode file line by
line through any vendor's send_gcode_line.
- PrusaSerialPrinter's connect/send_gcode_line are real (not stubs): a
held-open MarlinSerialConnection (src/printer/marlin_serial.rs) writes
each line and waits for Marlin's "ok" before sending the next. Config
changed from com_port: i16 to port: String + baud_rate: u32 to hold a
real device path.
- Bambu: BambuGenericPrinter + BambuV1Printer/BambuV2Printer collapsed
into one BambuPrinter, since which MQTT/BambuMQTT version (v3.1.1/v1
vs v5/v2) a printer speaks is discovered at connect() time (or forced),
not something config should pick a type for - the same physical
printer can change after a firmware update. printers.toml gets a new
"bambu" vendor (auto-detect, the default) alongside bambu_v1/bambu_v2
(force a specific one).
- Bambu's gcode_line request is now built for real via
continuum-schema-instance against continuum-schemas' JSON Schema,
picking the v1 or v2 schema directory based on the detected protocol
version, instead of a hand-written serde struct.
- Added rumqttc as a dependency (not wired up yet - the real MQTT
v5-then-v3.1.1 fallback connect and the publish/receive plumbing are
still stubs).
Co-Authored-By: Claude Sonnet 5 <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_01MWQVtBGxHYLkVw2kBupd5g
id in printers.toml is just a label you chose for config purposes - nothing
ties it to a specific physical printer, and renaming it (or reusing it for
a different unit down the line) would silently break the pin lookup and
re-trigger trust-on-first-connect for hardware that was already trusted.
The serial number is the one thing about a printer that can't change, so
that's what a pin should be keyed by: certs/pinned/<sn>.pem instead of
certs/pinned/<id>.pem.
Verified against a real TLS server: pinned a printer under one id, renamed
it in printers.toml with the sn left unchanged, and confirmed the second
run found the existing pin silently (no re-TOFU) rather than re-pinning.
The manual fetch_bambu_cert workflow works but needs two commands and a
printers.toml edit. ensure_trusted() collapses that into one call, using
the same trust model SSH uses for host keys:
- a pin already on disk (certs/pinned/<id>.pem) is used directly, no new
trust decision is made on every run
- no pin yet + bundled CA verifies fine (current-gen printers): nothing to
do
- no pin yet + bundled CA fails (P1P, etc.): auto-pins via
trust-on-first-connect, same as fetch_bambu_cert, but automatic
- an *explicit* pin (you set ca_cert_path yourself) never gets silently
auto-pinned over — a failure there is a real error
examples/auto_connect_bambu.rs demonstrates the one-command flow.
Verified all three states against local test servers, not just compiled:
first run with no pin auto-pins and connects; second run against the same
server is silent (no re-TOFU message) and just verifies against the pin;
third run after swapping the server's certificate correctly FAILS instead
of silently re-pinning — confirms the security property survives the
smoother UX.
octoturgeandClaude Sonnet 5